Drinking Water Disinfection
Water Treatment Analyzers & Controllers
Drinking Water Disinfection can easily be accomplished using the EMEC LDSCL PLUS range of Chlorine controllers.
They are NSF approved, and use Amperometric sensor technology for real-time, accurate measurements of Chlorine in water. The controllers provide mA, relay and pulse output signals to control Chlorine dosing pumps and to reliably control the amount of Chlorine in the water. Alarms can be programmed for High and Low levels, and there are also options for Ethernet, or Modbus communication.
Below is an installation of an EMEC LDSCL PLUS Chlorine analyzer / controller system with a chemical dosing pump, controlling the amount of Chlorine in drinking water to 0.5ppm from the after being filtered.
Other Applications
- Split and Isolate the above signals to be taken to more than one location
- Re-transmit signals from a remote panel meter display
- Magnetic installation of LED lighting for Control Panels or darker areas of the clean room
- Daisy Chaining of LED lights to increase light if required
- 10-30Vdc or 110Vac Options
Drinking Water Chlorination
