Remote Site Installation

Wireless Signal Transmission

The below is an example of an installation, where the Analynk Wireless Transceivers are used to send an analog Flow signal, with two alarms to the control room from a remote location. The remote site system consists of an Antenna mounted on the wall in side the control room, and signals are received from approximately 1 mile away, from the field flow meter, with additional trees, and a water tank in the way.

Some advantages of RealTech Controls system Model WTXRX-SYS listed below:

  • View or test the wireless signals being transmitted on a local display at either end, for commissioning, simulating, or trouble shooting
  • Easy calibration and setup via the local operator interface
  • Isolate, and Scale the signals to your custom requirements
  • Onboard RSSI (received signal strength indication)
  • Onboard Transceiver Power Selection
  • No software – simple plug and play
  • Low Voltage 24Vdc required, or 110Vac

Other Applications

Signal Conditioning –

  • Split and Isolate the above signals to be taken to more than one location
  • Re-transmit signals from a remote panel meter display

Control Panel LED Lighting –

  • Magnetic installation of LED lighting for Control Panels or darker areas of the control room
  • Daisy Chaining of LED lights to increase light if required
  • 10-30Vdc or 110Vac Options
Control Room with Analynk Wireles Transmitter

Control Room with Analynk Wireless Transmitter System

WTXRX System Zoom

WTXRX System zoomed, showing Flow Rate, mA Output, and 2 x Alarms

Tank with Flow Transmitter

Wireless Transmitter inside Remote Tank with Flow Transmitter. Antenna is mounted on top of the light post.

Site to Control Room Distance

Control Room to Remote Site Tank – 1 Mile